[hbirr] 14578: Set a better value for gap3 on read/write requests.

Set a better value for gap3 on read/write requests.
Modified: trunk/reactos/drivers/storage/floppy/readwrite.c
  _____

Modified: trunk/reactos/drivers/storage/floppy/readwrite.c
--- trunk/reactos/drivers/storage/floppy/readwrite.c	2005-04-10
16:41:32 UTC (rev 14577)
+++ trunk/reactos/drivers/storage/floppy/readwrite.c	2005-04-10
16:44:00 UTC (rev 14578)
@@ -430,6 +430,7 @@

NTSTATUS Status;
   BOOLEAN DiskChanged;
   ULONG_PTR TransferByteOffset;
+  UCHAR Gap;

PAGED_CODE();

@@ -523,6 +524,15 @@
     }

/* 
+   * FIXME:
+   *   FloppyDeviceData.ReadWriteGapLength specify the value for the
physical drive. 
+   *   We should set this value depend on the format of the inserted
disk and possible
+   *   depend on the request (read or write). A value of 0 results in
one rotation
+   *   between the sectors (7.2sec for reading a track).
+   */
+  Gap = DriveInfo->FloppyDeviceData.ReadWriteGapLength;
+
+  /* 
    * Set up DMA transfer 
    *
    * This is as good of a place as any to document something that used
to confuse me
@@ -703,7 +713,7 @@

/* Issue the read/write command to the controller.  Note that it
expects the opposite of WriteToDevice. */ 
       if(HwReadWriteData(DriveInfo->ControllerInfo, !WriteToDevice,
DriveInfo->UnitNumber, Cylinder, Head, StartSector, 
-			 DriveInfo->BytesPerSectorCode,
DriveInfo->DiskGeometry.SectorsPerTrack, 0, 0xff) != STATUS_SUCCESS)
+			 DriveInfo->BytesPerSectorCode,
DriveInfo->DiskGeometry.SectorsPerTrack, Gap, 0xff) != STATUS_SUCCESS)
    {
      KdPrint(("floppy: ReadWritePassive(): HwReadWriteData returned
failure; unable to read; completing with STATUS_UNSUCCESSFUL\n"));

RWFreeAdapterChannel(DriveInfo->ControllerInfo->AdapterObject);